 
 	LST is an RSX utility which may be used to list files in columnar
 format, with a date and file specifier heading. To use LST type LST and
 either enter an output and input specifier to CCL, or hit <CR> twice and
 LST will prompt LST>.  The LST command line is of the form
 
	outfilespec=infilespec/Switch:value
 
	where the allowed switches are,
 
	/LE:n		Paper  n  lines long.
	/WI:m		Paper m columns wide.
	/CO:n		Number of columns to break text into(0-10).
			If n=0, as many columns as will fit will be used.
			The number of columns is reset after each file is done.
	/TR		Causes lines to long to fit to be truncated. If not 
			specified, long lines are split and preceeded with a --->.
	/NH		Omit the LIST-11 header.
	/FF		If present a form feed in input file forces the start of 
			a new column in the output. If not present form feeds
			in the input file are ignored.
	/PA		PAUSE switch.  Only works when LST is in prompting
			mode.  At the end of each page LST will stop, and print
			LIST PAUSE> after which any input will cause LST to 
			resume output.
	/ED		Forces top of form character to be converted to ^D.
	/RO:n		Forces the output page to be n lines long and form feeds
			are replaced by a line of '=''s to delimit the page.
	/RL:n		Forces each line to be n characters long followed by a
			<CR> and <LF>.
	/UC		Causes lower case letters to be printed as upper case
			letters.
 
	
