Appendix 1 - adding extra drives to the Morrow Micro Decision

TEAC FD-35F-03U (3.5" double sided, 80 cylinders)

Connect the drive to the motherboard  with an MD11 floppy drive cable
used in reverse:  the card-edge connector goes to the motherboard and
the socket connector termination goes to the drive (two rows of .025"
posts on patterns of .100" centers).  Next to this double row of pins
is a single row of four .025" pins (.100" centers).  DC power is con-
nected to these 4 pins as follows:
pin 1 (closest to signal connector) +5 V
pin 2 - ground (+5 V return)
pin 3 - ground (+12 V return)
pin 4 (farthest from signal connector) +12V
Forward of the power and signal  connectors are a number of test and
configuration pins.  Insert a shorting bar across the pin pair MO to
allow the Motor On signal to be effective.   Insert another shorting
bar across pin pair D0 (drive select 0) for use as drive A or B with
revision 2 motherboards  (or for use as drive A, B, or C on revision
1 motherboards).  Configure the system for a double sided drive with
81 cylinders to format with 792K of free space.