SEAGATE TECHNOLOGY, INC.
1-800-SEAGATE
http://www.seagate.com
(C)opyright 1993
ST-43401N/ND Elite 3 SCSI-2 Fast Wide
ÚÄÄÄÄÄÄ Write Protect option enable
³ ÚÄÄÄ Not used
³ ³ ÚÄ Master off/Slave on - Spindle Sync
³ ³ ³ ÚÄÄÄÄÄÄÄÄÄ Terminator Power Source (see below)ÄÄ¿
³ ³ ³J4A ³ Ú Terminators (SIP on single, ³
ÚÅ Ú´ Å¿ J01³ ³ DIP on differential) ³
³o oo o³ J7 ÚÄijÄÄ¿ ÃÄÄÄÄÄÂÄÄÄÄÄ¿ J4B ³
³o oo o³o o o o o o-a-o-o³4o³o3³ÚÏÍÍÍ1ÚÍÍÍÍ1ÚÍÍÍÍ1 Power o o o o ³
ÀÄÄÄÄÄÄÙo o o o o o-b-o-o³2o o1³___________________ Ú12ÄGÄGÄ5Ä¿ o o o o ³
ÍPÍWÍAÍÍØÍØÍØÍØÍØͳÍ^ͳͳÏÍÍÍÍÍ( ×××××××××××××××××1)Í͵ 0 0 0 0 ÆÍØÍØÍØÍØÍÍ ³
8 4 2 1 ³ ³ ³ ³ ³ \ÄÄÄÄÄÄÄÄÄÄÄijÄÄÄÄ/ \ÄÄÄÄÄÄÄÄÄ/ ³ ³ ³ ³ ³
ÄÄÄÄÂÄÄ ³ ³ ³ ³ SCSI Cable Connector ³ ³ ³ ³ ³
³ ³ ³ ³ ³ ³ 68-pin ³ ³ ³ ³ ³
SCSI ID ÄÄÄÄÙ ³ ³ ³ ³ ³ ³ ³ ³ ³
Motor ÄÄÄÄÄÄÄÄÄÙ ³ ³ ³ ³ Spinup Delay (10 secs * ID) ÄÙ ³ ³ ³ ³
ÚGround ÄÄÄÄÄÄÄÄÄÄÙ ³ ³ Motor Start option enable ÄÄÄÙ ³ ³ ³
³Key (no pin) ÄÄÄÄÄÄÙ ³ ³ Parity enable ÄÄÄÄÄÙ ³ ³
³Spindle Sync (SSCLK-)Ù ³ Sweep Cycle enable ÄÄÄÄÄÄÄÙ ³
ÃSpindle Sync (SSCLK+)ÄÄÙ ³
ÀÄ port a and b (horizontal) ³
³
ÕÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ͸ ³
³ Terminator Power Source Options ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
³ 2 & 4 Ä Initiator supplies power over the SCSI Bus for terminators. ³
³ Drive supplies no terminator power. ³
³ 1 & 2 Ä Drive supplies power for its own terminator resistor-paks ³
³ but not to SCSI Bus. This is the factory setting. ³
³ 1 & 3 ³
³ AND Ä Drive supplies power for external terminator at end of the ³
³ 2 & 4 daisy chain. Terminator resistor-paks must be removed. ³
³ This option is recommended only for last drive on daisy ³
³ chain. ³
ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
T-RES descriptions: ST43401N 3 SIPs
ST43401ND 3 DIPs
ST-43401N/ND
Elite 3
UNFORMATTED CAPACITY _____________________3,554,871,600
FORMATTED CAPACITY (512 byte blk) ________2,912,484,864
AVERAGE SECTORS PER TRACK ________________99 (rounded down)
ACTUATOR TYPE ____________________________ROTARY VOICE COIL
TRACKS ___________________________________57,435
CYLINDERS ________________________________2,738/2,735 (user)
HEADS ____________________________________21
DISCS (5.25 in) __________________________11
MEDIA TYPE _______________________________THIN FILM
HEAD TYPE ________________________________THIN FILM
RECORDING METHOD _________________________ZBR RLL (1,7)
INTERNAL TRANSFER RATE (mbits/sec) _______35-52
INTERNAL TRANSFER RATE AVG (mbyte/sec) ___6.0
EXTERNAL TRANSFER RATE (mbyte/sec) _______20 Sync.
SPINDLE SPEED (RPM) ______________________5,400
AVERAGE LATENCY (mSEC) ___________________5.55
COMMAND OVERHEAD (mSEC) __________________<0.5
BUFFER ___________________________________512 Kbyte
Read Look-Ahead, Adaptive, Multi-Segmented
Cache
INTERFACE ________________________________SCSI-2 FAST Wide
BYTES PER TRACK __________________________49,000-72,800
SECTORS PER DRIVE ________________________5,696,655
BYTES PER CYLINDER _______________________1,058,400 to 1,587,600
TPI (TRACKS PER INCH) ____________________
BPI (BITS PER INCH) ______________________
AVERAGE ACCESS (ms) read/write ___________10/11
SINGLE TRACK SEEK (ms) read/write ________0.9/1.7
MAX FULL SEEK (ms) read/write ____________22.5/23.5
MTBF (power-on hours) Class A Room _______300,000
MTBF (power-on hours) Office _____________200,000
POWER DISSIPATION (watts) ________________
POWER REQUIREMENTS: Single-ended/Differential
+12V START-UP (amps) _3.98/4.60
+12V TYPICAL (amps) __1.90/1.88
+5V START-UP (amps) __2.37/3.48
+5V TYPICAL (amps) ___1.96/2.77
TYPICAL ( watts seek/read)_32.60/36.41
IDLE (watts) ______________28.34/31.81
USER MANUAL PART NUMBER __________________83327630
OTHER ____________________________________
Synchronized Spindles, Sweep Cycle Capability
** Already low-level formatted at the factory with six spare sectors
per cylinder, one spare cylinders/unit, one system cylinder/unit, and
one diagnostic cylinder/unit.
Physical:
Height (inches/mm): 3.25/82.6
Width (inches/mm): 5.75/146.1
Depth (inches/mm): 8.0/203
Weight (lbs/kg): 7.8/3.6
Seagate reserves the right to change, without notice, product
offerings or specifications. (08/08/94)
A copy of this specification file may be obtained
by FTP at
ftp://ftp.seagate.com/techsuppt/scsi/st43401n.txt.
Odd characters? Click here for help. A
version of this specification with the linedraw characters
approximated by text is available by clicking here.